Error Code E It
Defect of ice maker kit — malfunction of in-door ice maker motor
Moderate
Address soon - your appliance may not work properly
Also displayed as: E It
How to Fix
- 1
Step 1: Press and hold the FILL key for 3 seconds to enter icemaker test mode.
- 2
Step 2: Observe if icemaker runs 2 stages: harvest and fill water. If it completes both stages, mechanism is normal.
- 3
Step 3: If mechanism does not cycle, check wiring harness connection from Main PCB to icemaker.
- 4
Step 4: Check icemaker motor resistance. Replace icemaker unit if motor is defective.
- 5
Step 5: If harness is good and motor resistance is correct but error persists, replace Main PCB.
Other Error Codes for LRYXC2606D
Defect of freezer craft ice maker sensor — short-circuit or disconnection of craft ice maker sensor
Defect of Mini Cubed ice maker kit — malfunction of Mini Cubed ice maker motor
Defect of refrigerator sensor — short-circuit or disconnection of refrigerator sensor
Defect of freezer sensor — short-circuit or disconnection of freezer sensor
Defrosting failure — defrost sensor does not reach 40°F (5°C) within 80 minutes after defrost starts. Causes: disconnected thermal fuse, defective defrost heater, defective heater relay, drain tube blockage.
Defect of BLDC fan motor for freezer — no feedback signal from fan motor for more than 65 seconds
Defect of BLDC fan motor for ice compartment — no feedback signal from fan motor for more than 65 seconds. Causes: defect of BLDC motor connection, Drive IC, or TR.
Defect of BLDC fan motor for machine room — no feedback signal from condenser fan motor for more than 65 seconds